Ot-systems ET1111 series Manuale Utente Scaricare il pdf (Pagina 9)

ET1111 Series Installation & Operation Manual

www.ot-systems.com 9

3.5 Installation- Wall Mount

(a) Top view (b) Side view

Fig. 3.2 Dimension of Micro type units

 Installation: Mount the Micro type unit onto a fixture, or camera housings, e.g. a

plank, (either on the wall or on a flat surface) with at least 2 screws piercing through

the holes on the mounting frame to secure it in position.

 Startup: Connect the supply voltage to start up the Media Converter via the terminal

block.

 Removal: Locate and remove the securing screws. Usually, but not limited to, at

least 2 screws.

3.6 Connecting to Power

Bottom panel – Ethernet Port and Power

Input

Ethernet Port

NETWORK -

RJ45

connector

Power Input Assignment

12VDC

GND

Terminal

Block

12V

Top Panel

Bottom Panel

DC Terminal Block Power Input

Step 1: Connect the DC power cord to the pluggable terminal block on the bottom of

Media Converter and then plug it into a standard DC outlet.

Step 2: Disconnect the power cord if you want to shut down the Media Converter.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Nessun commento

Ot-systems ET1111 series Manuale Utente Pagina 9